Since the option of the grain direction is for all the panels, is there a command thats specific for each panel? The plinth’s grain direction should be vertical while the rest are horizontal.
Thanks
Gabby
Ness
Forum Posts: 1939
Subscriber Since: October 4, 2012
Offline
2
December 19, 2015 - 8:11 pm
Hi Gabby,
Here the video on how to set up grain direction from Polyboard to Vcarve,
I applied the grain direction in each panel in polyboard, but I’m not sure if Vcarve’s nesting recognized it. The direction of the grain didn’t match the one in polyboard. How do I match it?