Wood Designer forum
Double sided nesting in Vcarve|Forum|WOOD DESIGNER
Home
October 4, 2012
Offline
Hi Dam,
Yes, your method seems like correct way to set this up and should work well.
Best regards,
Ness
Hi Ness,
it’s not problem. I highly appreciate your effort to support me.
I think i made it.
I am using Vcarve nesting.
I set the pp dxf, in Tooled face export, i chose One single exported file per part.
After batch dxf processor in Vcarve, i made it nesting normally. Then i created Double sided job type, then i select all the vectors in face 2 then click Move to other side.
Is that process correct?
Thanks and best regards.
October 4, 2012
Offline
Hi Dam,
Are you using Vcarve nesting or Optinest?
For either you have to include the machining face in the layer names exported by Polyboard.
To do this use the PP DXF set up and add a panel face code:
In Vcarve set up the tooling templates to machine only the appropriate face.
As this is quite and involved subject, you might consider buying a training session so that we can look into setting this up together.
Best regards,
Ness
PS I’m actually on holiday so please excuse me if I can’t get back to you quickly.
1 Guest(s)
