I have attached back and front of shaker doors i have done in vcarve (disregard the hinges in back of door)
Thanks Caroline
Alex
Forum Posts: 1748
Subscriber Since: January 20, 2017
Offline
3
December 5, 2022 - 2:22 pm
Hi,
would it be possible to show me an example of your doors, but for me it’s more a question of pass depth than speed,
in general as chip thickness, rotation and feed rate are related, it is preferable to make several passes rather than slowing down the machining or rotation
Can someone look at my question please would like to run the door again today
Thanks Caroline
brendan kavanagh
Forum Posts: 136
Subscriber Since: May 12, 2020
Offline
1
December 2, 2022 - 2:00 pm
Hi
we are starting to do shaker doors on cnc, but one question we are using a end mill 80mm to do the pocket the spindle speed is 24000 which is fine when skimming board but is too fast for these doors what speed do you recommend for doors or is it just we reduce speed and see what works??