Wood Designer forum
Building first furniture piece with PolyBoard|Forum|WOOD DESIGNER
Home
November 6, 2024
Offline
Isaac said
Hi,No problems. See the attached image and follow the following steps:
1. Select the plinth
2. Select the left/right Links
3. Change ‘Type’ to Groove
4. Choose how far you want to extend your plinth.
Regards,
Isaac
Good tip! Thanks!
March 25, 2024
Offline
Hi,
No problems. See the attached image and follow the following steps:
1. Select the plinth
2. Select the left/right Links
3. Change ‘Type’ to Groove
4. Choose how far you want to extend your plinth.
Regards,
Isaac
November 6, 2024
Offline
Isaac said
Hi Normunds,Please see the attached video:
Additionally, See the following links to our help centre that may be helpful to you as you are learning the software.
https://wooddesigner.org/help-…..-hardware/
https://wooddesigner.org/help-…..cessories/
https://wooddesigner.org/help-…..g-methods/
Regards,
Isaac
Could you also add explanation on how I can cover the gaps of the plinth on each side? See image attach in the first message. Much appreciated.
November 6, 2024
Offline
Thank you Isaac for the quick video tutorial. It was very help full.
March 25, 2024
Offline
Hi Normunds,
Please see the attached video:
Additionally, See the following links to our help centre that may be helpful to you as you are learning the software.
https://wooddesigner.org/help-…..-hardware/
https://wooddesigner.org/help-…..cessories/
https://wooddesigner.org/help-…..g-methods/
Regards,
Isaac
November 6, 2024
Offline
Hi, everyone!
Just started my journey with PolyBoard and decided to go with test run using CabinetFiles.
I have almost finished the project. However, I have questions:
1. How do I add more legs and distribute them?
2. How do I extend the plinth beneath the cabinet?
3. How do I add just a panel instead of doors?
Here is the pic for plinth:
1 Guest(s)
