
August 7, 2014

Hi Hung,
Select sliding door when clicking add doors
I add this link showing you several videos for the project mode
https://wooddesigner.org/suppo.....ject-mode/
regards
Michel
The following users say thank you to Michel for this useful post:
hung vu

January 23, 2018


August 7, 2014

Hi Hung
here is a model made in project mode
regards
Michel
The following users say thank you to Michel for this useful post:
hung vu
August 7, 2014

Hi Hung,
This is possible (see attached cabinet file) that you can use to work on
In that model I added a free division 100mm from the bottom and made the bottom panel a nil material.
Add a double door at the top part and add shelves
Add a single door at the bottom part. This gives you the look you need. In the 3D visual the bottom door will open when you click on the open doors button but in the build you can just make it a fixed panel.
If you really want this to be fixed and not open in 3D then you could make it as a project. There the cabinet and the bottom panel will be 2 different create shape put together.
Regards
Michel
The following users say thank you to Michel for this useful post:
hung vu

January 23, 2018

Dear sir,
I can do: change glass door but i have problem: after add upright and shelve i can not add door (out side) (please see picture). Or i have add door first and then add upright and shelve ?
About plinth - I can turn on red light part plinth as you show. But it's still not what i want - i send you picture part plinth of cabinet i made (there a panel over 02 side left and right). The structure like picture i draw





August 7, 2014

Hi Hung,
you made a wrong build up of the cabinet. You used a fixed shelve as bottom part and made the actual bottom panel a nil panel. This is the reason why you are not able to add a plinth as these are to be situated below a bottom panel. So please correct this. You can achieve the same model of cabinet using the normal bottom panel but setting the side panels as overpassing the bottom panel and adding a needed length to it as I have showed in my earlier pictures
For the glass panel in the door you have to choose the doors 1 by 1and edit the structure by clicking on the 3dots button next to de the door name. Change the central panel material to glass called zz-glass,8.0
regards
Michel
The following users say thank you to Michel for this useful post:
hung vu

January 23, 2018


August 7, 2014

Hi Hung,
please attach your polyboard file
regards
Michel


January 23, 2018



January 23, 2018


August 7, 2014

Hi Hung,
I see you have overpassing sides in your example so I use a similar one
you need to point your cursor in the lower volume were you need the plinth added. It will light up in red
right click and choose add plinth
You can set the plinths you need ( front and back ) with eventual recess
When you have no overpassing sides you need to add an elevation plinth height
this will create the lower volume so that you can add plinths
Be informed that you can only add side plinths when your side panels are underpassing
regards
Michel
The following users say thank you to Michel for this useful post:
hung vu1 Guest(s)