November 8, 2013
July 17, 2020
When I am milling a board near the edge (making rectangle by inner tooling) my CNC shows 2 ways of cutter (picture 1) but when I want milling in the middle it shows me 4 ways (picture 2). Is it possible to make in Polyboard one way of cutter instead of 4? I can not set groove mode for milling while I have also circular saw for other grooves.
My second problem is about zero points for drilling. Is it possible to set different zero points for different drillings? In TpaCAD I can change zero point by writing in text box 0 or 1 but I can not find anything like that in Polyboard.
All the best