Wood Designer forum
batch processor |Forum|WOOD DESIGNER


May 9, 2022

hi michel
ive just tried it with the processor you said and its still doing the same thing the way i have been getting round it is by clicking the tab in vcarve next to where it says 3d view and a list comes down with
layer 1
0
outline
panel generic 0180
and deselecting either outline or panel generic
many thanks
ryan

August 7, 2014

Hi Ryan,
I guess you not only have installed the least 7.08C version but also the new libraries. This means your pp has been modified as we have reorganised them.
Can you do the same output with PP “DXF-Vcarve-OptiNest-EN-Vert/Re-2faces” and look if it is now ok ? the parameter for tooled faces export should be on One single file per part
Regards
Michel


May 9, 2022

hi Michel
ive added a smaller job to show you the problem with vcarve
i hope i sent them right if not maybe a zoom meeting might be easier
the post processor ive been using is -Standard-EN-Conv-1face.plb-export
once i open it in vcarve and use the batch processor it lays it out on the page but if you click on an individual panel and move it you will notice the exact same panel is underneath it
hope this helps
many thanks
ryan


May 9, 2022

since the new update when i use the batch processor with vcarve its now placing parts on top of parts its and making double the amount of parts which obviously i dont need also now i seems to be placing parts upside down which it never used to do before i updated
Is there some settings i need to change i have gone into post processor options and changed export to all parts and project export folders to 1 folder per material and that used to work fine
hope to hear from you soon
many thanks
ryan
1 Guest(s)
