To give a specific name to the cutting maps, go to Tools > Options and in the tab DXF Export, in the Filename box, type the prefix you want on the the cutting maps.
Hope this is helpful,
Best regards,
Ness
Thanks , my mistake my question was about Opticut.
Please look attached image!
BW! Ain
Ness
Forum Posts: 1939
Subscriber Since: October 4, 2012
Offline
2
October 19, 2020 - 4:31 pm
Hi,
To give a specific name to the cutting maps, go to Tools > Options and in the tab DXF Export, in the Filename box, type the prefix you want on the the cutting maps.