Wood Designer forum
October 4, 2012
It’s not yet possible to match grain across panels in OptiCut.
We can do this in OptiNest and the same feature is under development for OptiCut.
This should be ready in a couple of months time.
August 23, 2016
This section is reserved for pre-sale questions.
Please note that for all your technical questions, you have to subscribe to Premium Support.
Hope it will help.
All the best,
February 13, 2017
Is it possible to make some sort of grain matching to drawer fronts. For example if one would have 3 drawers with vertical grain how can i match them later in opticut? At the end I will be exporting to cutrite and to saw.
Same question applies to kitchen fronts with horizontal grain. how to match? Is there an easy way?