Wood Designer forum
Adding hardware to fittins list|Forum|WOOD DESIGNER
Moderator
August 7, 2014
Offline
Hi Jonas
here is an example of a wireframe support. The size will not be accurate but it shows that it is possible with Polyboard
3d accessory created of the wireframe.
groove created as separate hardware with a rule that starts at 10mm from the front of the shelf
added peg holes
About the domino’s
they are not in our library as dominos gets applied with a manual machine or do you intend to drill them on a CNC ?
regards
Michel
December 17, 2021
Offline
Hi,
Im trying to set up Polyboard with some of the fittings i normally use but i cant find them in the library.
Is it possible to use wire shelf support like this:
https://www.carl-ras.dk/tradhy…..6/44817007
It requires a 3×15 mm groove in both sides that goes through the back and stops ~10 mm from the front.
I would like to use dominos in different sizes (4×20, 5×30, 6×40 mm etc) but i cannot find it in the fittings links list.
Where can I find it?
thank you:)
1 Guest(s)
