Angles on cuts|Forum|WOOD DESIGNER

Home Forum PolyBoard Angles on cuts

Angles on cuts

Rooms Made Simple

Member

Full

Forum Posts: 111

Member Since:
September 1, 2022

Offline

October 28, 2024 - 2:40 pm

Thanks for the quick response.

This is exactly what I need, I hadn’t seen this as I had turned off “Toolings” in the document print as for a project this can give you 40 pages and my panels arent showing holing at the moment.

I hadn’t realise the angles were also on these pages.

Thanks again

Dean

Isaac

Moderator

Forum Posts: 1389

Member Since:
March 25, 2024

Offline

October 28, 2024 - 1:48 pm

Dean,

See the attached video.

Regards,

Isaac

1-2-1 Support & Training | Help Centre | How to use the Forum

Rooms Made Simple

Member

Full

Forum Posts: 111

Member Since:
September 1, 2022

Offline

October 28, 2024 - 1:29 pm

Hi folks,

When creating an angled unit of any type, as default Polyboard usually shares the angle to the items meet when cut. It does not however show you the angle and we are having to work this out manually.

Could Polyboard show me these angles and also print them on the paperwork so the guys putting them together can get straight to cutting them?