Log In
Home
back milled to deep
Alex
FRANCE
Forum Posts: 551
Subscriber Since:
January 20, 2017
January 20, 2017
Thanked 173 times in 551 posts
Reputation: 7084
Offline
2
February 16, 2021 - 8:17 am
Hi,
Without your parameters I can’t see,
But on CIX this setting gives me better and readable results
Hope that’s helpful
Dennis Goedhart
Forum Posts: 26
Subscriber Since:
November 7, 2020
November 7, 2020
Thanked 0 times in 26 posts
Reputation: 130
Offline
1
February 14, 2021 - 12:23 pm
Hi,
The routing of the back has been milled too deep in the side walls. My back wall is 9 mm and the
milling is 12.5 mm deep. This should be 9 mm. The diameter of my cutter is 16 mm.
I see in bsolid that the y is 4.5 mm. I think this should have been
1 mm with a cutter diameter of 16 mm.
I cannot upload the cix?
Best Regards,
Dennis
Forum Timezone: Europe/London
Most Users Ever Online: 256
Currently Online:
Guest(s) 1
Currently Browsing this Page:
1 Guest(s)
1 Guest(s)
Top Posters:
terry: 253
mark nichols: 148
Tom Cleaver: 123
jimbouk: 105
Christopher Paré: 97
syslab: 97
Duayne Naugle: 91
Kerf Works: 85
Conor Devoy: 83
Jack Travis: 77
Newest Members:
Griffin Bender
Domagoj Pevec
Aris Mintals
ENDER KUMRU
moe helal
moe helal
Mthombeni Cay
Shivani Patel
Dragan Lucic
Paul Preston
Forum Stats:
Groups: 2
Forums: 8
Topics: 1467
Posts: 8117
Member Stats:
Guest Posters: 4
Members: 125547
Moderators: 0
Admins: 10
Administrators: Ness, Stefan, michel melon, Carole Bosy, Alex, admin, Laly, ipatrick, Fatima, Crystal
Usage Policy