Log In
Home
October 4, 2012
Offline
Hi Philip,
The files you have sent are the Post Processor report files.
Can you post the Polyboard cabinet files ?
I can then show you how to set up and export the Polyboard DXf files and nest in Vcarve.
What version of Polyboard are you running?
All the best,
Ness
January 9, 2016
Offline
Here is a copy of the base cabinet I created.
Could you send it to Vcarve and see if it will work for you?
Also let me if you could step by step what you did to make
it work.
Thank you,
Philip
November 8, 2013
Offline
Hi Philip,
The videos on worktops in this section might help:
https://wooddesigner.org/suppo.....ject-mode/
For toe kicks, have you watched these videos on kick frames and plinths:
https://wooddesigner.org/suppo.....s/carcass/
Let me know if they help. Otherwise, I'll ask Ness to reply in full when he gets back from training next week.
Thanks,
Stefan
January 9, 2016
Offline
Hello Everyone,
THIS IS MY FRIST POST.
I have a box I want turn into a base cabinet for a kitchen with no hardware.
I installed my grooves and also install my toe kick.
What video do I watch to show me how to replace the top panel
and back panel with two smaller panels like the ones in a standard kitchen cabinet?
How do I add panels and change the dimension of a panel in a standard cabinet box?
I open a standard kitchen base cabinet and remove all hardware.
I want to raise the bottom panel to meet the toe kick?
Also can I change the dimensions of the toe kick with a standard kitchen base cabinet.
What video do I watch to do this?
Thank you,
Philip
1 Guest(s)
Usage Policy