Wood Designer forum
October 4, 2012
To set up the holes on the cabinet side setup the hardware like this:
Then set up a unique rule that positions the hardware.
The rule has to be set like this:
– Type = single
– direction reversed
– reference = the interior (draw) zone
– Offset distance from the bottom of the zone to the hole centres
If you need a video, please sign up as a full member and post your request on the forum.
Hope this is helpful.
All the best,
August 11, 2015
in one of the videos, you showed how to add the sliders/runners beneath the drawer itself, but not on how we could setup drillings in the cabinet (drawer zone) and how install the runners in the cabinet itself.
Would you mind show how this could be done?