Wood Designer forum
Built in drawers|Forum|WOOD DESIGNER
Alex
Forum Posts: 1835
Subscriber Since:
January 20, 2017
January 20, 2017
Offline
hi,
Yes set the face of the drawers to NIL and control slacks of face are set to 0mm,
The first drilling should be 37mm from the front
Cheers Alexandre
Conor Devoy
Forum Posts: 145
Subscriber Since:
January 28, 2018
January 28, 2018
Offline
Hi all,
I have a project with 50mm thick pull out shelves on Blum tandem runners.
I draw them as built in drawers to locate the hardware holes on my cabinet.
I can’t see where to turn off the drawer facades and I think if I leave them on my drawer hardware will be back by 18mm off the front edge of my cabinet.
Is there a way to have a drawer with two sides, a front, a bottom and a back but not facade?
Thanks, Conor
Forum Timezone: Europe/London
Most Users Ever Online: 365
Currently Online:
Guest(s) 27
Currently Browsing this Page:
1 Guest(s)
1 Guest(s)
Top Posters:
Ness: 1939
Tom Cleaver: 162
mark nichols: 160
Conor Devoy: 145
brendan kavanagh: 141
Duayne Naugle: 130
Blake Simpson: 104
Zaheer Abbas: 100
Robert Coxhead: 63
Patrick Maylor: 63
Newest Members:
Randy Blue
Andrew Gabbitas
dermotcoll
TESTING TESTER
Anthony Andrews
Abderrahim Laroussi
anvari@idnc.ca
Jose luis Ferreyra De Moraiz
Sam Russell
sarlejla
Forum Stats:
Groups: 2
Forums: 7
Topics: 2191
Posts: 11896
Member Stats:
Guest Posters: 4
Members: 306
Moderators: 0
Admins: 11
Administrators: Stefan, Michel, Carole, Alex, admin, Laly, ipatrick, Crystal, Fatima, Darren, Isaac
© Simple:Press —