Wood Designer forum
Change tool sorting in post prosessor|Forum|WOOD DESIGNER
Full
September 16, 2024
Offline
Hello,
as you say, there was settings in the biesse software that made the sorting impossible.
when changing this is worked as we wanted from polyboard.
best regards Martin
Moderator
March 25, 2024
Offline
Hello Martin,
This is the correct way to adjust your tooling sequence.
If this is not making changes, then your tooling sequence is most likely coming from an order set in your Biesse software. Try and find this, and adjust this in your Biesse software.
Regards,
Isaac
Full
September 16, 2024
Offline
Hello,
when i make cabinets in my eko 2.1 i want the sawblade (groowing) for the back 3mm plates and the drawer bottoms 6mm to be done in the end.
as it is now the machine does it first and then make all holes and milling around the profile.
i want all holes/milling etc to be done before the sablade.
i have tried to change in the post prosessor settings. there i finds “sort tooling”. where i put groowing at bottom.
when i make new files and test in machine, its the same.
have i been changing the wrong setting?
best regards Martin.
1 Guest(s)
