Wood Designer forum
Customizing face frames and saving to methods |Page 2|Forum|WOOD DESIGNER
October 4, 2012
Offline
Hi Nigel,
Best to do a quick TeamViewer session to sort out your config.
When would you like to meet up?
Cheers,
Ness
Hi Ness
Could you help please, Ive just installed 7 but cant get the quick design toolbars up, I look on the forum and done as you have said to Jan and still no joy, I’m going to be out on site fitting a kitchen today so wont have be able to get back on till tonight.
Regards
Nige
October 4, 2012
Offline
Hi Nigel,
To print the inside sizes of a cabinet;
In cabinet edit mode,
– make sure that View>Dimensions is on,
– click in the volume to show the inner dims,
– click right and in the context menu select “Permanent Dimensions”
The inner sizes will be displayed permanently, even when you print the drawing.
It’s easy to set up a fitting link for but hinges just use a groove in the hardware setup.
and apply as normal.
Best regards,
Ness
Hi Ness
When you build a cabinet and you put shelves in it, how do you get a print out with the measurements to show where to place them?
Thanks
Nige
Hi Ness
Is it possible to make a fitting link for butt hinges?
Thanks
Nige
October 4, 2012
Offline
Hi Nigel,
The way to do this is to split the inner panel into 2 panels before applying the door structure.
Once the double back is framed select the inner panel and use the “Surface split” command to make 2 panels.
Then apply a framed structure to each panel:
If you add a negative slack to the surface split it will give you the overlap necessary for the rebate:
Best regards,
Ness
1 Guest(s)
