Wood Designer forum
cut out |Forum|WOOD DESIGNER
Home
January 20, 2017
Offline
Hi,
2 ways, manually to each party
or add and save into Sub-methods fitting-links
All the best, Alexandre
May 12, 2020
Offline
Hi Alex
referring to my previous message re split in the backpanel of unit , we now want to assign the screws to the 2 separate backs how is this done??
Thanks Caroline
January 20, 2017
Offline
Hi Caroline,
I make this video,
hope that’s helpful
All the best, Alexandre
May 12, 2020
Offline
Hi Alex
can you look at the 2nd unit also, when i add the double back it doesnt sit on the top and bottom shelf there is a gap again am i missing something attached unit again for you to look at
Thanks Caroline
May 12, 2020
Offline
Hi Alex
Thanks for reply with the 1st unit yes thats exactly what i want but when i do it the cut stays in the middle of the panel i’m missing something!!!
I have attached the unit again since i have done it
Caroline
January 20, 2017
Offline
Hi,
I’m not sure I understood correctly but here is my interpretation
With inner tooling for first unit
You can select side and choose to copy the structure, then past it to another side.
For the second, you want the back of the cabinet to be 400mm from the front, right?
you can use double back instead of first back
All the best, Alexandre
May 12, 2020
Offline
Hi
I have attached units
1st one is sink unit – we need to cut out a section on left and right gables only at the top dimension of cut is 45mm down by 18.2mm from the front of gable
2nd is single oven unit – the internal at the top (400mm) is different from the bottom (500mm) how do I put back on the top to sit on the fixed shelves that are 400 deep
hope this makes sense
Thanks Caroline
1 Guest(s)
