Hello again!

I have now made a cabinet with the “ajusted links” to make a fitting for the pocket/sliding doors. Thank you so much for help with that:) 

It seems to be working, but the tool milling the track withe the 6 mm tool seems to be working a bit hard. 

So back to one of the challanges regarding selecting correct tooling, I need more specific instructions.

My original quesion was:

Idealy I would want the system to select:

6-8 mm track with the T4-130- 6 mm

8-12 mm track with the T2-128- 8mm 

and 20 + mm track with the T1-203- 20 mm

You did send me a video showing me how to punch in the tool I wanted for this inner tooling, but I dont understand where I´m supposed to assign different tools different instructions? I can only give inner tooling one set of tool.

Am I supposed to do this under “inner tooling” or under “customized tools” maby ? 

thanks again. I will do this and then do a test.

If I later on would want to for example make a big pocket (or something of a bigger size). Do I then need to go in and change this every time, or can it be done with some options like I suggested in last post? Like this:

6-8 tool xxx

8-20 tool xxx

20+ tool xxx

Hello again Isaac!

Thank you so much for your help so far 😛 

I´ve now created a pannel-structure with inner tooling, as you showed me in the video.  I added this to a “test-box/cabinet”, but the machine seems to use the wrong tool. (T1-130 20 mm contouring and panel) and of course the track is way too big.

I hoped Polyboard/Homag automaticaly would read the dimensions and choose the proper tool based on the size. Maby we never got the settings for this correct ?

How/where can I correct this setting?  Is it in the PP ? We got help with the PP in the beginning. I´m not very confident about doing this my self.

Idealy I would want the system to automaticaly select:

6-8 mm track with the T4-130- 6 mm

8-12 mm track with the T2-128- 8mm 

and 20 + mm track with the T1-203- 20 mm

(see attached image for information)

Kind regards

Marianne H.O.