I have a couple of questions regarding doors:

1.

Is it possible to “hack” the Polyboard-system a bit, to make a version of both built in and applied global doors? Where the doors are built in (+inset with a slack in depth 30 mm) on the sides and bottom, but where it overlaps the top-panel with 15 mm. Like shown in attachments.

2.

Also, we want to integrate a type of pocket-door, where the doors slides out and down under a fixed shelf inside.

The concept is old/quite easy, but difficult for us to integrate to the machine. My thought is that we can do this more easily on the vertical divisions/side-panels but not quite as easily on the door-sides.

We have an old furniture as guide to how we want it. And attached are some pictures and technical information, to vision it.

As you can see the door it self has a groove that is connected to a tennon in the sidepanels/v.dividers, and the side it self also has a groove that is connected with a different tennon that’s attached in the back/underside of the door. The groove on the door also has a plastic-channel/track, but the groove on the sidepannels don´t have any “coating”. Everything slides very nice and smooth, so this works very good.

(since we will have a fixed shelf I have X-ed out the fittinglink to the shelf with a yellow X. Don’t mind this part. )

We are not sure if we can find exactly the same type of hardware (tennon, plastic-channel/track) as used here, therefore the dimensions maby need to be ajusted. Do you think this is a type of fitting that can be integrated ? Ee have the Homag Drillteq 200. So I suspect the door-groove will be a problem, and maby needs to be done manual.

But maby the panel-sides (both vertical division and leftside/rightside carcass) can be done in the Homag ? I really hope so.

Kind regards

Marianne Hagen Olsen,

Snekkerfabrikken AS