Wood Designer forum
Double back m&t - error! urgent |Forum|WOOD DESIGNER
Moderator
January 20, 2017
Offline
If necessary, you can read the DXF files with Nanocad 5 for free, but you have to register,
Instead, you can send me your DXF export for verification, and let me know the desired value.
Best wishes, Alexandre
February 22, 2021
Offline
Removed the postpro setting value. Thanks!
Moderator
January 20, 2017
Offline
Hi,
You have 2 levels of Slak:
– The first is given by the sub-method “Groove and oversizing”
– The second is given by Post-Pro Setting
At the moment, in DXF, a non-through mortise like in your cabinet is considered as a non-through groove
According to this, the non-through groove measures 50+2+(4*2)=60mm
All the best, Alexandre
February 22, 2021
Offline
The gap that has been created on the side panel for the M&T is way longer than it needs to be, but not showing up on polyboard. Only noticed on Vcarve.
The M&T should be about 50mm in total and should only be a .5/1mm gap around the edge, but it appears to have a 10mm space around it for some reason..
1 Guest(s)
