Wood Designer forum
Drawer assembly greyed out|Forum|WOOD DESIGNER
Moderator
January 20, 2017
Offline
Hi,
Noted , if there are no parts, there is potentially nothing to configure.
and to remember this preset, it is done by the drawers sub-method, which works on the same principle as the “cabinet boxfull sub-method”.
Hope that’s helpful, Alex
May 2, 2023
Offline
Hi again,
I figured it out. The components was ticked “off” in the assembly and in the drawer method. Removing the already placed shaker drawers and changing the drawer parameters to all components “active” solved the issue.
All the best
Oscar
May 2, 2023
Offline
Hi there
I have a drawer type for drawers with Shaker fronts attached. And compared to my other types I can’t change the depth (or anything) through the assembly option while adding the drawer to a zone. As far as I can see, it’s set up the same way as the other types. My drawer types are currently only set up in a way, that ensures correct placement of the runner fitting holes, and the attachment of a specific type of drawer front. This mean that the only parameter I change is the depth for less deep cabinets.
Cheers
Oscar
1 Guest(s)
