Wood Designer forum
Edgeing|Forum|WOOD DESIGNER
October 4, 2012
Hi Peter,
Here’s a video that shows how to make a sub method from the existing Quick Design sub method.
I attach also the cabinet that contains the new material and sub method.
If you want, you can just “restore” the edging material and sub method to add them to your libs.
All the best,
Ness
October 4, 2012
Hi Peter,
Here’s a video that shows how to use the Quick Design libraries to easily change edging.
If you want to use different edging on cabinets and facades I can set up a Quick Design method for this too.
All the best,
Ness
Hi Ness
I would like to have a sub method so that I can change my edging on my cabinets from 1mm to 2mm and the same with my cabinet fronts.
Some times I may want 1mm to may cabinet components but can only get 2mm for my fronts or visa verse, so I would like to have the ability to change as required.
Not sure how to go about this.
Many thanks
Peter
1 Guest(s)