Thank you for quick reply and all your help so far helping me to learn a great software! Much appreciated. Talk soon.
All the best,
Tomas
Michel
Forum Posts: 990
Subscriber Since: August 7, 2014
Offline
2
May 12, 2021 - 6:49 pm
Hi Tomas,
You have to add a little extra space to the external zone. If your upright is 18mm you can set the external zone to 18.001mm. This will allow the panel
If you need to add on the cabinet without changing the actual cabinet width, you must place the external zone as outer.
If used as inner the panel will reduce the cabinet width to keep the same overall dimension.
I am trying to add end panel on the wardrobe using Upright function but getting this message ,,The Zone is not large enough to include an Upright of the selected Type.” Could anyone tell me what I am doing wrong here? Thank you in advance.