Wood Designer forum
Export of angle units |Forum|WOOD DESIGNER
Full
March 4, 2024
Offline
thanks very much for your help
Moderator
January 20, 2017
Offline
Sorry about the confusion
Since start I have checked most of parts out of cabinet back and I think Isaac on the same way.
When you have through drilling and/or milling on both faces PolyBoard always export on the same direction…
See from cabinet rear (back to front) for frontage panel, back or parallels to frontage
See from Left for Sides and Upright,
See from Top for horizontal panels,
and like you said the only way is to make no through drilling because in case of single face drilling/milling this frontage where on the Top surface
Cheers, Alex
Full
March 4, 2024
Offline
sorry this one below is the one i screenshotted
so the melamine timber i have is only high gloss on one side which i need on the inside of my unit. 
this unit is lower on the right side but when i export to v-carve it mirrors it and has the lower side on the left. meaning the high gloss side is now on the outside of my unit
Moderator
January 20, 2017
Offline
Sorry , I have made set of test and I don’t find any issue,
Can you point part having issue?
The VCarve file you send is not the same as on your screenshot
Cheers, Alex
Moderator
January 20, 2017
Offline
Perfect! Thanks I let you know soon if I find something strange
Full
March 4, 2024
Offline
is this okay
Moderator
January 20, 2017
Offline
I don’t see issue from Vcarve files , can you send me Your PolyBoard Project and export of our PP used
All the best, Alex
Full
March 4, 2024
Offline
i checked i already have it on ignore in the post processer setting
here is the v-carve file.
i found if i put a shelf hole on the back it will come out the right side facing up but if its a through polit hole is comes out facing the wrong way
Moderator
January 20, 2017
Offline
Hi,
The problème when you made an output to VCarve in first view you can’t see if it’s the inner face or a transparency top view…
Can you send me your VCarve file?
Cheers, Alex
Moderator
March 25, 2024
Offline
William,
See the attached video. Run a test output with these changes and let me know how it goes.
[Subscribe to Premium Support to view this media]
Regards,
Isaac
1 Guest(s)
