Wood Designer forum
Gola Profiles Best Setup|Forum|WOOD DESIGNER
Moderator
March 25, 2024
Offline
Hello,
See the following video:
[Subscribe to Premium Support to view this media]
This should help to create different Gola profiles.
Regards, Isaac
Moderator
March 25, 2024
Offline
Hello Patrick,
Thank you for sending me this.
I will need a little bit of time to prepare an example. I will make one and send it to you when I can.
Regards, Isaac
Full
May 3, 2023
Offline
Hi Isaac
Attached are the data sheets, the first 2 pages are the ones I need to set up for now and could be 2 , 3 or 4 drawers.
Thanks
Moderator
March 25, 2024
Offline
Hello Patrick,
Do you have some technical sheets for the profiles that you are using? With these, I will show you an example of what you could do.
Regards, Isaac
Full
May 3, 2023
Offline
Good morning Gents
I would like to know what the best way is to set up horizontal top and intra drawer Gola profile cut-outs in vertical divisions and end panels. I tried to play around with different methods but its hard to get something consistent but failed. As I also have different suppliers I would like also to be able to adjust the cut-outs easily to match the different sizes. For the top rails they need to be set to the zone and then the interim rails somehow to the rebated draw tops within the zone. I don’t have 3D DXF files for most of them so using that as a basis has been troublesome as I tried to use the method that you did some time ago for the blum profiles (this also put a central profile at the top in addition to the top profile which was a but messy). Can you please let me know what the best approach is?
Thanks
Patrick
1 Guest(s)
