1. I need face framing above and below the doors, to match the face frame I have at the sides. The top and bottom framing butt up to each other in the centre, so one piece of framing is longer than the other by the thickness of the frame.  Where the top and bottom facings join the side facings they are mortice and tenoned in by 8mm. 

 

I have managed the frame at the top, using double backs, but you will see the right hand top face frame is too long. I can recess it back to the correct length but this splits the material of the top. I cannot apply a face frame under the doors.

 

2. I need a plinth that sits behind the facing that is underneath the 2 doors.  Using double backs only allows me to position a plinth under the left or right side, I have left this on the drawing as an example.

 

3. On all cabinets I need to be able to add an end panel that fits on the side of the cabinet and behind the face frame.  This is from the top of the cabinet down to the floor.  If you hi light the external zone on the side that is basically what I want to fill with an end panel.  A video on this would be very useful.

 

Thank you

 

Dave