Wood Designer forum
Ignore Links if one of the Panels is Nil|Forum|WOOD DESIGNER
Moderator
January 20, 2017
Offline
Hi,
Sorry this option is only for full nil panels only.
There is actually no solution to do this directly.
Cheers, Alexandre
Full
November 13, 2019
Offline
Hi,
I think the only way it can be done is if the settings at “Fittings links list”; “Apply the rule to the surface split” is also at “Fittings links Sub-method”
Full
November 13, 2019
Offline
Hi,
No. I’m trieing to creat a fittings links sub-method to add Cam and dowels to my back cleats/rails with a variable position if that is possible.
My top and bottom cleats are always the same and I’ve created a 2,3 and 4 back cleat “double back” with a Panel structure for each with from “surface split” with Proportional Mode. So the cleats aren’t the same distance each time.
I’ve changed the “surface split” to Distance mode for now and changed the dowels to but would like to do it proportional.
Secondly, for the boxfull top and bottom and the fixed shelves, I have the same dowel and cam configuration and when ‘n change the top to rails there’s still a dowel in the middle where the Nil panel is.
Attached are both cabinets
Moderator
January 20, 2017
Offline
Hi,
Can you send me your cabinet?
Have you added the link manually?
Cheers, Alexandre
Full
November 13, 2019
Offline
Hi,
Am I doing something wrong?
When I select “Ignore Links if one of the Panels is Nil” then there should be no Fittings on both sides where one of the panels is Nil or just on the Nil panel?
Because fittings on the opposite panel from the nil panel are still visible.
Regards,
Ryno
1 Guest(s)
