Wood Designer forum
Labeling on maestro |Page 3|Forum|WOOD DESIGNER
Moderator
March 25, 2024
Online
Hello Andy,
I can see that you haven’t yet activated the SCM PP reg file, for label output in Maestro. (See earlier post in this chat where I first mentioned this)
To do this, go to Setup > Reg > PP Report in our Quick Design libraries and run the SCP PP reg file. This will format your SCM Post Processor so it integrates properly with your labels in Maestro.
Regards,
Isaac
Full
January 18, 2024
Offline
Hi Isaac
So I’ve uploaded just the bottom parameters as per photo, hope this helps
Thanks
Full
January 18, 2024
Offline
Hi Isaac
Wont allow me, saying file is too big
Moderator
March 25, 2024
Online
No sorry Andy,
Please go to PolyBoard, and select Tools>Save Parameters.
This will save a parameter file and allow me to see your PolyBoard set up. Please forward this to me and I will be able to see your PolyBoard set up.
Regards,
Isaac
Full
January 18, 2024
Offline
Full
January 18, 2024
Offline
This is the cuttling list options
Full
January 18, 2024
Offline
Hi Isaac
Do you mean this? 
Thanks
Moderator
March 25, 2024
Online
Hello Andy,
Can you please send me a copy of your Parameter file?
I will look at your current export format, and I will advise on what can be done.
Regards,
Isaac
Full
January 18, 2024
Offline
Morning
So this worked but it only produces labels with the part, ie top, bottom ect, not what the cabinet is called. so when i nest multiple cabinets they all just have the part name on them, how do i get the cabinet name on it too? I’ve tried changing the format of the label and tweaked the label on maestro.
Ive attached a photo, so ideally i need the 500 cab on the label with the part
1 Guest(s)
