Wood Designer forum
Material Thicknesses|Forum|WOOD DESIGNER
Moderator
January 20, 2017
Online
Hi,
As the reference is the outside, it is imperative that the thicknesses are correct otherwise the top will inevitably overflow
If this is not the case, the groove will not fit into the thickness of the panels.
Slack of grooves can be adjust with Sub-methods Groove and oversizing
Cheers, Alex
Full
November 3, 2022
Offline
Hello,
My cabinets are designed using a generic 18mm board however my actual real life material thickness is more like 18.5mm. Do I need to change this in the material properties in polyboard as well as my CAD/CAM software (V-carve)…i assume the material thicknesses in each software need to correspond and be accurate to the actual thickness of the board.
Secondly, i am getting a slight lip around my tenon, do i just need to increase (or make the negative number more negative) in my post processer options for grooves (Recess of non through grooves)?
Lastly, my top does not seem to be flush with my sides here, both panels have the same thickness edging on? this might be something to do with my material thickness inputs?
thanks
Oli
1 Guest(s)
