Wood Designer forum
Method problem|Forum|WOOD DESIGNER
Full
January 28, 2018
Offline
I think we found out what it was.
My brother was using a default method instead of one of the methods I have set up.
I’ll attach a screen shot to show you what was happening.
Thanks Alex.
Moderator
January 20, 2017
Online
Hi,
Stefan will email you with upgrade information.
I finally opened your project with 6.07c,
Can you let me know which parts give you trouble? For now when opening DXF with CAD programs I don’t see anything
But I see one issue on LHS Left side with tenon & mortise with fixed shelves
All the best, Alexandre
Full
January 28, 2018
Offline
I meant to say, do you think I’ll get an answer today.
I have to make a decision to redraw or not.
Thanks Alex
Full
January 28, 2018
Offline
Hi Alex, I’m using 6.07c
As a matter of interest how much does it cost to upgrade?
Moderator
January 20, 2017
Online
Hi,
Sorry I can’t open your project, in version 7.06a
Can you let me know which version you are using?
After your reply, I‘ll contact the development team to have more information and come back ASAP.
That way I’ll know if they have adjusted more specific issues, maybe you have encountered bugs that have been corrected since.
All the best, Alexandre
Full
January 28, 2018
Offline
Sorry Alex, I think I have uploaded now.
Moderator
January 20, 2017
Online
Hi,
Sorry for the delay, but I don’t see any attached files,
Cheers, Alexandre
Full
January 28, 2018
Offline
Hi guys, my brother did a program for a job and has run into a problem.
When we go to nest it, the gables etc. come out as frames instead of solid panels sometimes inside eachother.
I can’t see what setting is causing this.
I’m attaching the drawing, if you could look at it I would appreciate it as I don’t want to have to redraw.
Regards and thanks,
Conor
1 Guest(s)
