miter joint drilling|Forum|WOOD DESIGNER

Home Forum PolyBoard miter joint drilling

miter joint drilling

Alex

FRANCE

Moderator

Forum Posts: 2110

Member Since:
January 20, 2017

Offline

January 7, 2021 - 11:30 am

Hi,

The fittings link I attached is only for mitred, and works for me with the test I have done, it work with differences angles.

For other Minifix products you must use other settings

Attachments

mini.png (127 KB)

1-2-1 Support & Training | Help Centre | How to use the Forum

Guest

Guests

January 5, 2021 - 5:31 pm

Hi Alex,

According to the manual of our minifix, size A (FIG 1) must be 6.5 mm from

inside panel. In your example, is the minifix in the

center of the panel? I can adjust the y measure but it is related to

the angle and is not correct at different angles.

Best Regards,

Dennis

Attachments

FIG-1.jpg (11 KB)

Alex

FRANCE

Moderator

Forum Posts: 2110

Member Since:
January 20, 2017

Offline

January 4, 2021 - 3:57 pm

Hi,

The cabinet was uploaded in my previous post, minifix 44

(EDIT: make sure you’re logged in to access it at the end of post)

All the best

1-2-1 Support & Training | Help Centre | How to use the Forum

Guest

Guests

January 4, 2021 - 3:39 pm

Hi Alex,

I follow the link: “Find cabinet attached with link in PB 7.05G

What cabinet you mean? (the link is de download page of polyboard?)

Regards,

Dennis

Alex

FRANCE

Moderator

Forum Posts: 2110

Member Since:
January 20, 2017

Offline

January 4, 2021 - 9:40 am

Hi,

You can try to change your preference drillings of a miter joint edges to Parallel

and use this minifix B44

Please find cabinet attached with link in PB 7.05G

All the best, Alexandre

Attachments

mitdril.png (28 KB)

1-2-1 Support & Training | Help Centre | How to use the Forum

Guest

Guests

December 30, 2020 - 6:30 pm

This is the minifix i want to install.

Attachments

180471115.jpg (3 KB)

Guest

Guests

December 30, 2020 - 6:11 pm

Hi Alex,

Thanks for your reply. Can you indicate how I 
get the Y size correct from the inside?
I have already tried many options 
but it does not work. See red line.

Thanks

Attachments

edge.png (130 KB)

Alex

FRANCE

Moderator

Forum Posts: 2110

Member Since:
January 20, 2017

Offline

December 30, 2020 - 2:25 pm

Hi,

But you’ve set face to edge (Band), with this Polyboard follows 4mm along the edge and perpendicular from the underpassing panel

All the best, Alexandre

Attachments

edge.png (130 KB)

1-2-1 Support & Training | Help Centre | How to use the Forum

Guest

Guests

December 26, 2020 - 11:43 am

Hi,

If I want to make a bore in 2 mitered panels, the y measurement 
is incorrect. The diameter is 8, so y = 4 then the bore 
should be equal with the inside?

Best Regards,

Dennis Goedhart

Attachments

Schermafbeelding-2020-12-26-123416.jpg (46 KB)

Forum Timezone: Europe/London

Most Users Ever Online: 1068

Currently Online:

Guest(s) 39

Currently Browsing this Page:
1 Guest(s)

Wood Designer forum