When grooved you can use the Groove and oversizing sub-method to add spacing in length and thickness, but so you don’t have conflict when using a tenon, in order to add more space in thickness the easiest way is use a thicker panel.
I’ve figured out how to add the extra spacing to the left and right in oversizing but it won’t add any above or below the cut-out for mortice/tenon shelfs
Connor
Forum Posts: 56
Subscriber Since: February 22, 2021
Offline
1
March 5, 2021 - 2:24 pm
I have set up mortise & tenon type shelves on my unit and i want to increase the gap of the hole that is cut out on the side panel, to allow a bit of spacing (from 12mm to 13mm).
What is the best/easiest way to do this? It would be the same everytime, so if i can save it somehow that would be great.