Wood Designer forum
January 20, 2017
May 18, 2014
I would like to use the grooving and oversizing sub method to apply different values for the height and width of parts to oversize. Quite often we need to oversize a scribe piece in the width but not in the height or vice versa. Other parts may also require different values. Currently only a single value for both dimensions is allowed. This then requires each piece to be manually input or changed (time consuming and very much open to error).
I feel this must be an easy modification for the developers to implement. I think I have asked about this before and I would be very grateful if this could be looked into.