Wood Designer forum
Panel Generation failed|Forum|WOOD DESIGNER
Moderator
March 25, 2024
OfflineHello Tom,
See the following video:
Best regards, Isaac

Full
January 24, 2023
OfflineI forgot to add…the notch should be 10mm more in each direction for tolerance. Wall depth is 105mm, so a notch of 115mm (in the front to back axis (depth) and the other direction (left to right/width) is 91mm from the back left edge to the corner of the wall, so 101mm notch.

Full
January 24, 2023
OfflineHi Isaac,
I’m try to create a notch around the back left side of Cabinet B in the middle. The challenge is after the notch, I cannot then add a hanging rail. It says panel generation failed. I’ve tried both notching first then adding the rail, and adding the rail, then notching the cabinet, to no avail.
Any suggestions would be welcomed as this is a live job. I’ve attached the project file for you and upgraded to 8.10j for the software.
Cheers,
Tom
1 Guest(s)
