Wood Designer forum
Polyboard Cabineo Holes incorrect on one model|Forum|WOOD DESIGNER
Home
March 25, 2024
Offline
Hi,
No worries. Let me know if there is anything else I can help with.
Regards,
Isaac
May 3, 2023
Offline
Hi Issac
I have now been through the XCS and the nesting and there seems to have been an issue and it looks like someone remade this with the holes in the wrong place and not as per the file.
Sorry for raising a non issue. (they will drive me mad one day)
Cheers
Patrick
March 25, 2024
Offline
Hi Patrick,
I am looking at the file and trying to understand what is incorrect. See the attached image, are you saying that when assembled this panel is on an angle?
Also, can you please send me a copy of your parameter file?
Regards,
Isaac
May 3, 2023
Offline
Hi Isaac
Email sent, I checked in the 3D and 2D and all looks perfect, but for some reason the holes output in the file are not in the correct location.
Cheers
March 25, 2024
Offline
Hi Partick,
Please Zip the file and email it to [email protected]
In the email, please say that the file is for Isaac.
I will look at this for you. Regards,
Isaac
May 3, 2023
Offline
Hi
We just installed a cabinet but when we went to put the mobile shelves in the divider in the top of the cabinet was not vertical and is 5mm out. On interrogating the model this is not the case, but when I went into more detail the holes for the cabineo in the fixed shelf are dead centre whereas they should be offset circa 5mm as per the cabineo model. I wont be able to load the model onto the portal as its too big. How can I get this to you as this is something that we have not had an issue with and now we have to uninstall the cabinet. In the attached it is shelf 7 where the holes in the middle should be set off circa 5 mm to left
Thanks
PAtrick
1 Guest(s)
