Polyboard project design advice|Forum|WOOD DESIGNER

Hi Yusuf,

To confirm the final point we discussed this morning on rotating a model in Polyboard - hover with the mouse over a corner of the model then left click. The double arrow icon will then go light red inside. You can then left click and hold to drag the model around.

To be more precise, you can right click on the model and select 'Rotate Selection' or 'Turn Round':

Then select the angle of rotation. There are quite a few extra parameters you can have a play with here including selecting the point of rotation (from a corner or from the middle of the model for example).

I'll be in touch again soon to arrange a full online demo with you to help you decide if the software will work for your business.

All the best, Stefan

Hi Yosuf, can you do tomorrow at 2pm UK time, 3pm your time. If so, please make sure you've got TeamViewer installed from this page: https://wooddesigner.org/teamv.....er-set-up/

Thanks, Stefan

Hi Yusuf, no problem, I'll email you to set up a TeamViewer session. Please note, Premium Support includes these sessions but they are limited to 15 minutes. For full 1-2-1 training, please consider ordering a training pack here:

https://wooddesigner.org/train.....g-service/

But before that, let's get the session done and see if that's enough. Best, Stefan