Wood Designer forum
Pre Mill Edge|Forum|WOOD DESIGNER
Home
December 7, 2018
Offline
We Optimize through Optinest only
Our new edge bander will be setup to mill the edge thickness i.e. 1mm edge 1mm mill, 2mm edge 2mm mill.
However we will be keeping one of our existing edge banders as back up which does not mill.
regards
Dave
January 20, 2017
Offline
Hi,
To be sure, I need to know your whole process.
For information,
With Nesting solution, PolyBoard > OptiNest
Milling of parts with edge thickness deductions > PostPro setting to Net Dim.
Milling of parts without edge thickness deductions > PostPro setting to OverAll Dim.
With a part-by-part solution, PolyBoard > OptiCut
Pre-cutting part with Oversizing > sizing and drilling on CNC > Edge bander with pre mills
PB cutting list option Net Dim for OC, edges thickness 0mm! > CNC PP setting OverAll Dim
Net Dim = OverAll Dim – edges thickness + Oversizing
For exemple,
parts 600x600mm with 5mm oversizing and edges 2mm
The part in the cut list is 601×601, which leaves only 1 mm for the part size on the CNC instead of 2.5 mm per panel edges.
All the best, Alexandre
December 7, 2018
Offline
Thanks Alexandre
We were wondering if we change the Post-Processing Properties – General – Dimensions – Overall Dimensions (instead of Nett Dimensions)
Presuming this will give us an option to flick between Pre Mill to cut Edge Thickness if needed
Regards
Dave
1 Guest(s)
