Wood Designer forum
query on unboxing |Forum|WOOD DESIGNER
Full
May 12, 2020
Offline
Hi Alex and Michel
Thanks very much i deleted the casing and did a second unboxing and it worked
Thanks for your time and patience.
Caroline
Moderator
January 20, 2017
Offline
Hi,
We discussed this with Michel yesterday, but I’m still not sure I understood,
If you are talking about this, please remove the nil shelf, and the current inner casing, and add a new inner casing between the top and bottom.
OR you can add a second unboxing on the top and back.
Otherwise, do a quick drawing of the pipe positioning and I’ll make a video for you.
All the best, Alexandre
Full
May 12, 2020
Offline
Hi Alex
Just wondering did you get to look at this would like to get it finished
Thanks very much
Caroline
Full
May 12, 2020
Offline
Hi Alex
I have attempted the inner casing but if you look at the unit attached there is gap between casing and the hole out on the left hand side. Can you advise what i did wrong??
hope this makes sense, pipe is coming in from right hand side along back of unit and out.
Thanks Caroline
Full
May 12, 2020
Offline
Hi Alex
Thanks for that , i also sent a second request on forum can you take a look when you get a chance
Thanks Caroline
Moderator
January 20, 2017
Offline
Hi,
We don’t have tool to do partial unboxing
But you can make them with inner casing and inner tools.
All the best, Alexandre
Full
May 12, 2020
Offline
Hi
i have attached a unit for you to look at i have unboxing on the left hand side but i dont want it running the full length of the back of unit just 150mm from the top
How is this done? Again can you send video please
Thanks Caroline
1 Guest(s)
