radius curve in a panel|Forum|WOOD DESIGNER

Home Forum PolyBoard radius curve in a panel

radius curve in a panel

brendan kavanagh

Member

Full

Forum Posts: 226

Member Since:
May 12, 2020

Offline

February 18, 2026 - 1:15 pm

Hi Isaac

thanks will try that

Caroline

Isaac

Moderator

Forum Posts: 1388

Member Since:
March 25, 2024

Online

February 18, 2026 - 11:57 am

Hi Caroline,

Yes, you can trace the curved radius with the “Draw Arc” tool in VCarve.

Then, assign a toolpath to it with the desired tool.

Best regards, Isaac

1-2-1 Support & Training | Help Centre | How to use the Forum

brendan kavanagh

Member

Full

Forum Posts: 226

Member Since:
May 12, 2020

Offline

February 18, 2026 - 11:39 am

Hi Isaac

re these radius curves attached is vcarve file Brendan is asking can we use the 4mm end mill at the end to go on the curve or not?

Thanks Caroline

Attachments

Radius-curve-panels.zip (30 KB)

brendan kavanagh

Member

Full

Forum Posts: 226

Member Since:
May 12, 2020

Offline

February 17, 2026 - 4:50 pm

Hi Isaac

apologies yes of course its a square wink we have adjusted 2 measurements to 100mm and we can now do the curve

Thanks again

Caroline

Isaac

Moderator

Forum Posts: 1388

Member Since:
March 25, 2024

Online

February 17, 2026 - 3:49 pm

Hello Caroline,

I am sorry, but I don’t understand your request.

If each side has a dimension of 200mm, you would have a square, rather then a corner cabinet.

This attached PDF is not possible.

Regards, Isaac

1-2-1 Support & Training | Help Centre | How to use the Forum

brendan kavanagh

Member

Full

Forum Posts: 226

Member Since:
May 12, 2020

Offline

February 17, 2026 - 2:52 pm

Hi Isaac

thanks for the video, i have done a panel in polyboard (see attached) but can’t get all sides to be 200mm as in sketch for me to then do the curve can this be done?

Thanks Caroline

Isaac

Moderator

Forum Posts: 1388

Member Since:
March 25, 2024

Online

February 17, 2026 - 1:20 pm

Hello,

See the following video:

Regards, Isaac

1-2-1 Support & Training | Help Centre | How to use the Forum

brendan kavanagh

Member

Full

Forum Posts: 226

Member Since:
May 12, 2020

Offline

February 17, 2026 - 10:51 am

Morning

Please see attached sketch could you advise how this can be done?

we want to do several different radius (5,7,9 and 11)

Thanks Caroline

Forum Timezone: Europe/London

Most Users Ever Online: 1068

Currently Online: Isaac

Guest(s) 23

Currently Browsing this Page:
1 Guest(s)

Wood Designer forum