January 20, 2017
September 11, 2017
February 13, 2017
I am facing an issue rebuilding my manufacturing methods.
Attached pic and cab file.
- What I want to achieve is a groove on cabinet bottom front edge 3x8mm in full length.
- Cabinet side to bottom link reference from the panel front edge, not assembly front edge.
Bottom is made from assembly because it uses a bar material as handle. And I want that for the cutting list..
I see that i can now add a fitting link between surface splits. I can groove that way but it is not very parametric.
Or is there another workaround for this kind of setup?