January 20, 2017
The development team is waiting for your files to analyze and correct this point.
- The cabinet file,
- Your parameters file (Menu "Tools/Save Parameters"),
- The part exported PP file.
You can follow the corrections at any time on the post on the link below
All the best, Alexandre
February 13, 2017
When using two files for two faces then the tool correction is OK. But when using a single file for both faces then the correction goes wrong. See pictures attached.
Also, this does not work unless there is a macro inserted between program lines of two faces to instruct machine to pause, operator to flip the panel and resume machining.
Where MR,value=mrrX means rotating over X axis, benefical to maintaining the front edge of the part.