hello

i don’t want to rotate the fitting, it should be same orientation as top and bottom, only need to fill the gap greater than 80cm

Here are the files

Thanks

Zack B.

Hello Isaac

I had follow the instructions and adjusted the orientation of the fittings (as you can see). It is working just fine for height up to 100cm. If I want to change the height to 200cm plus, I will need to fit few more fittings between top and bottom. Do I need to create different orientation of the Gola fitting or it can be changed  with different rules?

Thanks

Zack B.

Hi Isaac,

I have no problem with creating the fittings and add them to the project or cabinet. I had added the screen shot of the Volpato Gola fitting that were added to the cabinet. Only, I need to add the rules that will add second raw of the fittings depend on the  with and length of the side panel. Also, I need to change these rules for cabinet or side panel that must be attached to existing cabinet.

Regards

Zack B.