Wood Designer forum
wall import |Forum|WOOD DESIGNER
Moderator
March 25, 2024
Offline
Hi William,
Yes, it was made with a cabinet. You can add them all to the project mode, and add units to the room as you usually would.
See an example of this through the following link:
Regards, Isaac
Full
March 4, 2024
Offline
hi isaac,
thanks for getting back to me. am i right in saying that room was used creating a new cabinet using the zz wall method. if so how do i add my units into that room then
Moderator
March 25, 2024
Offline
Hello William,
Sorry, that file was created in the latest version of PolyBoard 8. You will need that version to view it.
You can also try this older file attached. Please make sure you have updated to at least 7.12d.
Regards, Isaac
Full
March 4, 2024
Offline
Hello,
Sorry the file wont open for me in polyboard it says “unexpected file format”
Moderator
January 20, 2017
Offline
Hello William,
It is not possible to create sloping walls directly in Project mode, but you can create a large piece of furniture that will act as a room and allow you to model sloping walls, as in the library model attached below.
All the best, Alex
Full
March 4, 2024
Offline
Is it possible to make a sloping wall at all
Moderator
March 25, 2024
Offline
Hello William,
When you import a wall or floor DXF file in the project mode, it will always import from the Plan View (top view).
Therefore, this is not possible to import a sloping wall in this way.
Best regards, Isaac
Full
March 4, 2024
Offline
sorry isaac i thought i uploaded it
Moderator
March 25, 2024
Offline
Hello William,
Can you please attach the file.
Regards, Isaac
Full
March 4, 2024
Offline
Hello,
i want to import a wall that has a slope. i have attached a file below of the wall. But when i import it with dxf file it gives me a floor plan rather than a sloped wall. Could you help me please
1 Guest(s)
