Wood Designer forum
Width & Height the wrong way round for drawer box components |Forum|WOOD DESIGNER
Moderator
March 25, 2024
Offline
Hello Ashley,
Sorry this took me so long to reply.
This is referencing the width and height of the individual panels, and not linked to the rotation of the overall cabinet.
This is how the component will be exported in a cutting list. This is normal for PolyBoard.
Best regards,
Isaac
Moderator
March 25, 2024
Offline
Hello Ashley,
I have the file this time, thank you.
I will look over the file and respond to you as soon as possible, I apologise for the delay.
Best regards,
Isaac
Full
June 13, 2025
Offline
Hello
Hopefully this is worked this time, i wasn’t pressing ‘start to upload’ apologies.
Moderator
March 25, 2024
Offline
Hello Ashley,
I cannot see this file again. Please try to attach it again.
After attaching it, make sure you press “start upload”.
Regards,
Isaac
Full
June 13, 2025
Offline
Hello
I’ve drawn a 3 drawer box as a test to make sure ive set all the parameter correct for using the Hafele runner system we use.
First issue when exporting to cut list ive notice the width and height of the components seem to be the wrong way round. The dimensions are correct in terms of the width for example….
600mm carcass width – 36mm for the sides = 564mm internally .
564mm – 5.5 lateral slack each side = 553mm for overall width of drawer box
553mm – 36mm drawer sides = 517mmm drawer base width
however is listing the height as 517 not the width
attached file
1 Guest(s)
