Ok thats great thank you for your time and if we dont speak have a good xmas.
Regards
Mark
Michel
Forum Posts: 984
Subscriber Since: August 7, 2014
Offline
6
December 15, 2022 - 9:45 am
Hi Mark,
You can add a cutstring to fill in the gap and eventually adapt it to the thickness of the riser. This is currently the only option as it is not yet possible in stairdesigner that the riser would follow the curvature of the step.
Thank you for the response i was trying to fill in the void of where the riser curves round the bullnose step theres a gap between the front riser and the newel post,hope this makes sense.
Regards
Mark
Alex
Forum Posts: 1748
Subscriber Since: January 20, 2017
Offline
4
December 15, 2022 - 7:53 am
Hi,
The void seems to be created by the penetration of the step into the post,