November 8, 2013
If you haven’t already, please check out the basic StairDesigner videos here: https://wooddesigner.org/suppo…..er-videos/, especially the ones on Getting Started and Stair Parameters (Part Properties).
Here’s a link to the forum thread Duayne mentioned which is also very useful: https://wooddesigner.org/forum…..tair-rule/
We can certainly design the stair for you too. You would need to upgrade to Full membership, then purchase either the StairFile Pro service (you do the design in StairDesigner, we review and revise it if necessary) or the StairPlan service (just send the spec and we do the design for you – no need to use the software yourself at all). Click here for more info:
March 1, 2015
you need to change the stair rule , it was explained to me in the stair building forum under “Stair rule “, check it out !
A rise of 8″ and a run of 9″ will get you very close to the 42 degrees that you are looking for .
The following users say thank you to Duayne Naugle for this useful post:Stefan
May 14, 2015