Wood Designer forum
Stairfile DXF|Forum|WOOD DESIGNER
Moderator
August 7, 2014
Offline
Hi Bruno,
There are always two outlines on the stringers, which are for the inner and outer outlines. For the straight version, they are identical, but with winded steps, the riser part is at an angle to follow the step angle. So if you can’t handle the angle, you take one of the outlines that fit most and delete the second one.
About the step notches. You are using a cutstringer, so there are no notches like you would have on a regular stringboard. If you mean notches below the step to locate the cutstringer, then no, these are not available. Such steps are mostly attached with L- brackets welded on the inside, and the steps get screwed to it.
regards
Michel
January 25, 2023
Offline
Hello Alex,
It looks like the stair stringers are cut at an angle.
Laser cutting does not allow this.
There should be notches in the steps.
Possible?
regards,
Bruno
January 25, 2023
Offline
Thank you Alex,
Some lines are in double in some dxf’s.
What should I do?
Cheers,
Bruno
1 Guest(s)
