Wood Designer forum
how to change G54 to different G55,G56 or G57|Forum|WOOD DESIGNER
Ness
Forum Posts: 1939
Subscriber Since:
October 4, 2012
October 4, 2012
Hi Vahid,
Stairdesigner doesn’t export gcode only raw DXF.
The G54 origin is set by your CAM software.
If you are using Vcarve you can set up different off sets simply by setting a material offset:
(Sorry I only have the French interface on Vcarve on my computer)
An easier way to work with different offsets is to set them in the machine controller.
The way to do this depends on the controller you have on the machine.
But in general you will be able to choose or type in the G54 value as you need them directly on the machine before you place the parts.
This makes all the Vcarve setups the same.
Hope this is helpful,
Best
Ness
Forum Timezone: Europe/London
Most Users Ever Online: 256
Currently Online:
Guest(s) 36
Currently Browsing this Page:
1 Guest(s)
1 Guest(s)
Top Posters:
Ness: 1939
Tom Cleaver: 162
mark nichols: 160
brendan kavanagh: 136
Conor Devoy: 132
Duayne Naugle: 130
Stu Robertson: 104
Zaheer Abbas: 86
Robert Coxhead: 63
Patrick Maylor: 62
Newest Members:
Keith Shelley
Kate Polak
zorsim
Janio Soares
Kitchen Jockey
pg_panel7
hadialnajjar
Isaac
butnariu daniela
Yosi Siboni
Forum Stats:
Groups: 2
Forums: 7
Topics: 2103
Posts: 11512
Member Stats:
Guest Posters: 4
Members: 260
Moderators: 0
Admins: 11
Administrators: Stefan, Michel, Carole, Alex, admin, Laly, ipatrick, Crystal, Fatima, Darren, Isaac
© Simple:Press —