Thanks for this. Unfortunately this hasn’t seemed to work. I set the edge banding to 0mm, saved and exported and printed out the new opticut report. But the measurements are exactly the same.
I could be missing something here…
Regards,
Tom
Alex
Forum Posts: 1763
Subscriber Since: January 20, 2017
Offline
2
November 20, 2023 - 7:42 am
Hi Tom,
The easiest solution is to set your edges from PolyBoard with thickness of 0mm,
This solution allow to display edges on labels and report,
that’s take few second to turn back , or doing pre milling on specific edges
Our edge bander now has pre milling. How do we change the settings in Polyboard and/or Opticut so that the cut list sizes are not reduced wherever there is edge banding?
If you have any visuals to explain this I would really appreciate that.